bricked ovale evic

[hishambachir]

Hi,
i just my my ovale evic and when trying to upgrade the firmware a ''read error'' appeared and now impossible to start the evic
i've tried the tutorial on their FAQ website but nothing happened
any ideas on how to solve this issue?
thank you in advance

FAQ ovale tutorial:

If a firmware update is interrupted before it's finished (power loss, disconnected data cable, ect) the eVic may lose partial or all functionality. Affectionately known as a 'brick'. In most cases the eVic can still be recovered though. Here is how:

1. Insure that you have installed MVR to your computer.
2. Disconnect the eVic battery from its control panel.
3. Connect the control panel to your computer using the USB cable.
4. Hold the fire button for 2 seconds.
5. The MVR screen should now automatically open on your computer.
6. Click 'Upgrade My ecig' and allow the update to complete.
7. Disconnect the eVic control panel and close the MVR screen.
8. Reconnect the battery to the control panel.
9. You will see a factory default message.
10. The eVic can now invoke MVR normally again but has no other functionality.
11. Preform the normal firmware update to restore it's functions.
    (see 'How do I update the eVic Menu?')

 

[Sthur]

Check page 2 on this thread. Someone explain another reset method.

Also did you try another USB cable or another USB post on your computer?

http://www.e-cigarette-forum.com/forum/evic/470877-evic-bricked-2.html

Welcome to ECF and hope this helps.