EVic VT Troubleshooting
- Thread starter ClassySine77
- Start date
- th_trl_thread_readers 0
- Status
What wattage is it set at, and what is the resistance of the attached atomizer?
I assume you're on the Nickel heads. What temperature do you have it set to?
Hm. That's a bit odd. At this temperature/wattage you shouldn't really be burning your juice. I mean, with a TC mod you shouldn't be burning anything at all. Do you have another head you can swap in? Since it's cotton, if you've burnt it once, it's done forever. Although really it shouldn't have burnt at all..
I visited my vape shop and the guy checked it out. When he started hitting it then I did after there was no problem. A little while later I've been taking some hits and it just burns my throat a bit. Should I inhale faster or slower?
What airflow setting do you have the tank set to?
If you have the airflow mostly closed off and you're trying to "lung hit" it (ie: not like a cigarette) then yes, that'd probably result in juice not getting to the coil fast enough (though, again, temp control should prevent that).
If you have the airflow wide open it's still possible you're ripping it too hard. Maybe try slower pulls and see if that fixes it. Also try "priming" the wick by taking a few dry puffs (ie: puffs without pressing the fire button) just to pull juice into the coil/wicks.
I have it set to about 75% open, 25.0 W, 300 F NI now, 2.34 volt, .22 atomizer, just inhaled somewhat slowly and it gave me a burnt hit felt like it was burning my throat as well.
If you're using the nickel or titanium coil in their proper modes, you cannot set the wattage below 30. In TC mode, you can only set the evic-VT between 30 and 60 watts.
You should lock the res while vaping to get the consistency out of it..
You only can adjust the temp and wattage..the res should remain as you locked earlier..
- Status
Similar threads
