EVOD bcc on vision spinner help

[Trickydick666]

I'm still kinda new to vaping (just over a month) and have a EVOD bcc clearomizer on a vision spinner 1300mah vv, been using 1.9ohm coils and just got a 2.5ohm coil for it today. What is a good voltage range for it? Was typically vaping 70/30 pg/vg but am now using a 50/50 mix...any advice on voltage and such?


a bad day at the track is better than a day of not running at all

 

[mattiem]

Best thing to do is set it on the lowest setting, take a vape. Turn it up and repeat. Keep doing this until you taste the slightest burnt taste and then just bump the voltage down. Spinner + evod is my all day every day vape and this is how I fine tune my flavors.

 

[ScottP]

If you have an Android device, download Vaper's Toolbox, scroll over to the Power Tool tab and put in 1.9 ohms and whatever voltage you were using to get your old wattage. Then switch to the calculate voltage mode and put in 2.5 ohms and whatever the old wattage was and it will tell you the voltage to use.

If you don't have an Android device let me know your old voltage and I will calculate it for you.

 

[graybuck]

A general rule of thumb is add 2 to the level ohms in the head. I generally find 1.9 ohm head runs well at 3.8-4 volts and a 2.5 runs nice in the 4.3-4.5 range.

 

[Trickydick666]

A general rule of thumb is add 2 to the level ohms in the head. I generally find 1.9 ohm head runs well at 3.8-4 volts and a 2.5 runs nice in the 4.3-4.5 range.

So far been running between 4.4 and 4.5


a bad day at the track is better than a day of not running at all