Having fallen in love with hemp wicked EVOD's and Pro tanks, and with a Billet Box on pre-order I decided to spend a little time working on a way to use these heads in a Billet Box. Not yet having the Billet Box, I do not know with 100% certainty that this will work, but I'm quite sure that it will as long as the bottom o-ring of the BB tank lines up OK at the bottom.
I put this together with stuff laying around in my junk e-cig drawer. 510 adapter, and a used flanged DCT carto.
Eddie Adams is also working on something similar. Is a shame that the head needs to have base flange diameter reduced, otherwise someone with the right tools could easily make a drop in set made of SS that peeps not into making homemade mods could just drop in the already readily available Kanger heads.
The base is a 510 adapter with the pin removed and drilled out to 7/32". Male threads and top air slots also ground off. A lot of brass here so I have ordered a couple of SS 901-510 female adapters from Provape. Atomizer Adapter 901 to 510 Let y'all know how this works when I get them.
Here is the 510 adapter ground down and drilled. Take care not to damage the female threads. The head screws into this.
Here is the EVOD head with the bottom flange ground off so it will fit through the carto tank. I'll wick it later.
Here is a Pro Tank stem soldered into a DCT base. This is the part that comes pressed into a DCT carto. The flange and male threads have been ground off. I used a Pro Tank Stem rather than the smaller diameter EVOD stem since the PT stem fit snuggly into the hole that was left in the DCT end cap.
This is the EVOD head screwed into what's left of the 510 adapter.
Here it is all put together. More exposed brass than I would like, but if the 901-510 works, that will minimize it.
Next to a standard 510 carto.
I put this together with stuff laying around in my junk e-cig drawer. 510 adapter, and a used flanged DCT carto.
Eddie Adams is also working on something similar. Is a shame that the head needs to have base flange diameter reduced, otherwise someone with the right tools could easily make a drop in set made of SS that peeps not into making homemade mods could just drop in the already readily available Kanger heads.
The base is a 510 adapter with the pin removed and drilled out to 7/32". Male threads and top air slots also ground off. A lot of brass here so I have ordered a couple of SS 901-510 female adapters from Provape. Atomizer Adapter 901 to 510 Let y'all know how this works when I get them.
Here is the 510 adapter ground down and drilled. Take care not to damage the female threads. The head screws into this.
Here is the EVOD head with the bottom flange ground off so it will fit through the carto tank. I'll wick it later.
Here is a Pro Tank stem soldered into a DCT base. This is the part that comes pressed into a DCT carto. The flange and male threads have been ground off. I used a Pro Tank Stem rather than the smaller diameter EVOD stem since the PT stem fit snuggly into the hole that was left in the DCT end cap.
This is the EVOD head screwed into what's left of the 510 adapter.
Here it is all put together. More exposed brass than I would like, but if the 901-510 works, that will minimize it.
Next to a standard 510 carto.