When I put my evod heads on the protank unmodified it will read low load off and on. Anyone else getting this and know why?
- Status
How about the other way around? I have 2 EVODs but no protank. So far that I've seen the only replacement heads i can get are the textured base ones. 1: I dont like them very much and 2: The textured heads wont fit down into my Vamo V2 but the smooth base will.
Mine fits my Vamo too (SS V2), but I can barely get any airflow cause it's such a tight fit inside the drip well. I just use it on my Zmax instead.
I get an e1 on my provari occasionally... (pretty sure that is low load?) and yeah, about halfway thru the tank they started leaking like a sieve. The bottom connector looks like it is slightly shorter, thus causing the e1. Haven't found a reason why it'd leak tho, and I do not have any more wick without cannibalizing some more heads. Anyway, the protank heads are now in stock and I switched to that and they work great, lol. Either way, if someone knows of a fix that'd be good.
I've been running 1.8 Evod heads in my Protanks for over a month with no mods.
They work fine.
They work fine.
I got the 1.8ohm evod heads and get errors, once got a good ohm reading but the rest of the time was like .2 ohm or something lime that. Tried 2 out of the 5 heads so far then gave up and put the protank head back in.
- Status
Similar threads
