Finally did my first (successful) rebuild in my Igo-W!

[Kezrak]

Single "micro" coil (micro was the goal, it's basically just a smallish tightishly wrapped coil )

Now, the flavor is definitely better than my nautilus tanks, but with 1 .9 ohm coil around 3.5 volts the flavor is a bit lacking. I'm not sure if it'd be safe to raise it up (on my Provari) since I used cotton wicks. Anyone have any input?

 

[Myrany]

As long as you keep the cotton wet you can up the volts. I run them on a mech which with a fresh battery puts out 4.2 volts so you have some wiggle room going up for sure.

 

[Topacka]

At 1.9 ohms and 3.5 volts, you're only putting out 6.5 watts. The cotton won't burn unless it's dry, I vape on my cotton builds at 25 - 30 watts, but I've seen people on here who vape at close to or just over 100 watts.

 

[Kezrak]

At 1.9 ohms and 3.5 volts, you're only putting out 6.5 watts. The cotton won't burn unless it's dry, I vape on my cotton builds at 25 - 30 watts, but I've seen people on here who vape at close to or just over 100 watts.

Sounds good, but Jesus Christ, seriously at 100 watts? a .25 ohm coil at 5 volts would do it...but damn.

 

[Topacka]

Sounds good, but Jesus Christ, seriously at 100 watts? a .25 ohm coil at 5 volts would do it...but damn.

Yeah, not my cup of tea, that's for sure. I think the actual numbers were .17 ohm and 4.2 volts, which is 24+ amps. I wouldn't push my batteries that far unless it was in a controlled experiment to show somebody how stupid it is.

 

[Vappers]

Yeah, not my cup of tea, that's for sure. I think the actual numbers were .17 ohm and 4.2 volts, which is 24+ amps. I wouldn't push my batteries that far unless it was in a controlled experiment to show somebody how stupid it is.

Actually topacka- i thought it was your cup of tea!

I would vape closer to 100 watts if it didn't drain my battery so fast. At 80 watts it kills a 2500 mah battery in half a day.

Youve posted in alot of my threads, i found this amusing