Finally

[jchadbourne]

Bought my first mech today super stoked!!
Ss nemesis and an igo-w 3, I haven't built the igo yet but I have another igo-w with a 1.2 ohm dual coil build on it and its hitting like a champ. Im still a noob so any advice would be appreciated.

 

[jchadbourne]

Its a nemesis clone

 

[Topacka]

What exactly would you like advice on?

 

[jchadbourne]

I guess just on coil wrapping. I picked up some 28 gauge and some 30 gauge. How many wraps of 28 gauge for say 1 ohm

 

[Topacka]

I guess just on coil wrapping. I picked up some 28 gauge and some 30 gauge. How many wraps of 28 gauge for say 1 ohm

I couldn't say because it's dependent on the circumference of your wraps and the space between them. Make sure you have an ohm checker!

Once you get used to it, you'll be able to eyeball an ohm, and then pop it on your ohm checker and nod silently in your accomplishment.

 

[Keeferes]

I'm on my mobile, so can't link it, but look at my one stop noob shop thread. Hours of information in there.

 

[jchadbourne]

Thanks I'll look into that

 

[jchadbourne]

Im using my svd to check the ohms is that an accurate way or should I buy an actual ohms meter?

 

[Topacka]

Im using my svd to check the ohms is that an accurate way or should I buy an actual ohms meter?

I would invest in an ohm meter. Not only is it going to be more accurate, it'll be easier to check for shorts and you can build on it.

 

[ScottP]

I guess just on coil wrapping. I picked up some 28 gauge and some 30 gauge. How many wraps of 28 gauge for say 1 ohm

If you have an Android device, look for Vaper's Toolbox. It will answer just these types of questions.