Finding new love for higher ohms!

[cocacola31173]

I have kayfuns and usually build them around 1.1 to 1.3. Here lately though I have been building them aroun 1.8 to 2 ohms. I forgot how much I enjoyed the smoothness of a cooler vape. I don't go through near as much juice and my battery lasts a lot longer.

I tried sub ohm and its just not for me. I wish they would start coming out with tanks that don't have such an airy draw. I do have Lemo 2 which I can cut down. But I rebuilt a sub tank mini head to 1.6 bit even at one hole just way too airy for me.

 

[roxynoodle]

There are some. Even some other inexpensive ones:

EHPro Mini Buddha
HCigar HC Plus
Focusecig Focloud can be build single coil with one smallish airhole open

High end:
Gus Phenomenon Zest or Lite
Titanium Mods Ataman II (there is a clone of this also)
Taifun GS II (there are also clones)
Nectar (also clones)

 

[tj99959]

And then there is the good ole carto tank.

 

[Vaslovik]

I know people who build scary sub-ohm, like .2 just starting out with their first atty. All the cloud chasers in the B&M's here do that, and go even lower. I just cannot see the point. I do sub-ohm, but not like that. I never went below .7 ohm, and now I'm building my Krakens, my Origenny, and my DID for .8 ohm, because that's what works best and gives me the best vape. Then again, I'm not a cloud chaser, and never saw the point in that either.

 

[thetrucker]

I have lately started making 32 guage coils with 2.0 ohms and getting enjoyment lots of vapor and batteries lasting a lot longer.

Less heat--less gunk----tried the sub ohm twisted coat hanger wrapped in a Clapton coil thing and just seems like a lot of Hooplah.

 

[thetrucker]

Just started using this little gem----a smok rda---2.0 ohms use any battery to power this......

 

[tj99959]

 

[KentA]

I've been running around 1 to 1.5 ohm.
I really don't enjoy Hooplah.

 

[dbrandt01]

I have a tank you'd probably love. It's called the Calix by Leo. It's an RTA and the airflow comes from the 510 and is top fill. I was going to put it up in the classifieds but I keep procrastinating haha I'm used to lung hits and while it's a great tank, it's not as enjjoyable for me.

 

[thetrucker]

I have kayfuns and usually build them around 1.1 to 1.3. Here lately though I have been building them aroun 1.8 to 2 ohms. I forgot how much I enjoyed the smoothness of a cooler vape. I don't go through near as much juice and my battery lasts a lot longer.

I tried sub ohm and its just not for me. I wish they would start coming out with tanks that don't have such an airy draw. I do have Lemo 2 which I can cut down. But I rebuilt a sub tank mini head to 1.6 bit even at one hole just way too airy for me.

Try a rubber vape band or a rubber band and slide it down part way over the air intake hole and you can get a much tighter draw...

ps---small strip of transparent scotch tape will also work and keep the beauty of your

mod/clearomizer intact...