First coil and mesh build tonight.

[Joeseff]

I'm going to build my first Atomizer tonight so wish me luck and any hints or tips are very welcome

Cheers

Sent from my HTC One using Tapatalk

 

[ncvapfan]

Awesome! What are you building on?
Tips-
1) have something to vap on while your working
2) repeat #1
3) Watch videos/ research proven builds for your device
4) Wind your coil with how the terminations will be in mind. if terminating the wires under screws wrap the wire to go clockwise with the screw.
5) CHECK ohms/ work out hot spots
6) Proudly vap your face off!

There is a ton of great advice and build pics on here. You are entering the apex of vaping, good luck!

 

[Joeseff]

Thanks man got a 1.5ohm coil and it's hitting great on a kraken genesis Atomizer not bad for first try

Sent from my HTC One using Tapatalk

 

[rith]

Just build a my very first successful ss mesh on my ihybrid pure and it's awesome so far the only thing I can tell you is too do make sure you oxidize the mesh really good do you don't get crap metal taste. My first 4 builds all taste like metal before but tonight was different. I'm please with my results and conclusion is to vape this for a week straight to see I the flavor gets better. The taste is good but this has only been about 30 min of vaping on It.


Sent from my iPhone using Tapatalk

 

[Joeseff]

mine is hitting sweet never had vapour like it off my other set ups

Sent from my HTC One using Tapatalk

 

[Connor S]

Hey I just purchased a kraken and it's in the car for after the shift, did you start with just building one coil and wick? Or did ya jump right into two? I'll be building for a provari so I'm interested in what you did to get your ohms up there, most posts seem to relate to sub ohmers

 

[Joeseff]

Hey I just purchased a kraken and it's in the car for after the shift, did you start with just building one coil and wick? Or did ya jump right into two? I'll be building for a provari so I'm interested in what you did to get your ohms up there, most posts seem to relate to sub ohmers

I just used 400g mesh and 30 gauge kanthal wire, oxidised the mesh and wrapped 4 coils tested it and it came out at 1.5ohms on a single coil, not tried a dual yet.

Sent from my HTC One using Tapatalk

 

[Joka]

On my kraken I build two horizontal coils equalling .7, throw in the same amount of cotton as my drippers. I drip with it, and excess goes into the tank, which I turn upside down to auto drip =]

Sent from my SCH-I545 using Tapatalk

 

[Joeseff]

On my kraken I build two horizontal coils equalling .7, throw in the same amount of cotton as my drippers. I drip with it, and excess goes into the tank, which I turn upside down to auto drip =]

Sent from my SCH-I545 using Tapatalk

Can you show a pic of that build?

Sent from my HTC One using Tapatalk