First rebuildable setup(s)?

Status
Not open for further replies.

SunnyHours

Senior Member
ECF Veteran
Verified Member
Dec 8, 2012
140
129
35
Canada
I'm looking at getting myself into rebuildables, probably an easy to build dripper and also a tank system.
I'm really not into big voltage or sub-ohm. I use the mouth-to-lung inhale and I'm not a fan of the throat hit.
I'll be using it on a Provari 2.5. I would probably prefer a 2 post deck (I guess since I don't know anything about them)

I've seen the kayfun Lite and it's clones and they look super easy. However, I'm open to other suggestions.
As far as the dripping atomizer, there are sooo many that I don't know where to start, so I would really need you help on this one.
If you could also tell me what materials would be needed for the build with that particular suggestions, that would be awesome!

Thanks a bunch!:D
 

ShariR

Vaping Master
ECF Veteran
Verified Member
Jun 13, 2013
8,375
33,469
Nashville, TN
I have several Russian 91% and they have airflow control and I do not find them a tight draw. The Kayfun Lite Plus has airflow control. They both have a good size deck and are easy to build on. You can pick up a good clone, EHPro or Hcigar for around $40 at many vendors.

I have heard very good things about the Magma dripper. I don't have one so can't comment on it.

If you are a mouth to lung vaper I would not recommend the Igo-L. Yes, it is cheap and good for practice building but I found that I was getting a sore throat using it. It seems that I had to draw right to my lungs. A much different vape than any other topper I have used before. I have no problems with sore throats with my Russian or the Kayfun. I am also a mouth to lung vaper.
 

edyle

ECF Guru
ECF Veteran
Verified Member
Oct 23, 2013
14,199
7,195
Port-of-Spain, Trinidad & Tobago
I'm looking at getting myself into rebuildables, probably an easy to build dripper and also a tank system.
I'm really not into big voltage or sub-ohm. I use the mouth-to-lung inhale and I'm not a fan of the throat hit.
I'll be using it on a Provari 2.5. I would probably prefer a 2 post deck (I guess since I don't know anything about them)

I've seen the Kayfun Lite and it's clones and they look super easy. However, I'm open to other suggestions.
As far as the dripping atomizer, there are sooo many that I don't know where to start, so I would really need you help on this one.
If you could also tell me what materials would be needed for the build with that particular suggestions, that would be awesome!

Thanks a bunch!:D

I don't have one of these - magma, but it's on my wishlist.
I like the simplicity; the accessibility of the post holes - (my igo is a pita to push the wires through because the holes are low down inside the well)
the way the separation between the posts is maximized;
the air holes are below the deck and not on the side of the well so the well does not end up leaking through the airholes;

Am not sure if the center pin is adjustable; it looks like a slothead to adjust, but my igo look the same and turning it does not seem to work to move it out.
Also the slot head screws on the posts should be phillips; would be a pain to screw them back in if you accidentally unscrewed them all the way out.
1718100-2.jpg
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread