Fuzion Vapor and the VTR extension tube

Status
Not open for further replies.

HisDudeness

Full Member
Feb 20, 2014
11
0
King, NC
Alright I'm a little upset with this... I've had the VTR About a week now and really like it with everything except my Fuzion Poison Apple, and KrankBerry. Right before I bought the vtr I bout a new Pyrex tank for those two juices. It doesn't fit the VTR so I have to use the extension piece. With both juices using the extension I get this bad burntish taste. At almost any watt/volt it's like that, except really low where I'm not getting any hit. Anybody else had any issues like this? Any idea what it could be? :confused:
 

HisDudeness

Full Member
Feb 20, 2014
11
0
King, NC
Its just the pyrex tank with the fuzion juices. I tried it with the iclear 30s and it does change the taste some in other juices, but it doesn't burn them. Its a 2ohm tank, and i have replaced the coil. I tried volts and watts from 3.7v-5v, and 6w-14w and it was just awful. I just went out and bought a smaller tank tank that was pyrex. It seems to work fine now. Maybe my extension tube is defective.
 

jared87

Full Member
Feb 25, 2014
15
8
Madison, AL, USA
Sounds to me like you are having a wicking problem. What atomizer head are you using? Ill be honest. I love fuzions stuff. Especially the unicorn blood. Heres the thing. The juice is a little thicker. Depending on what type of wick you are using you may not be getting any juice delivered to the coil. Im not sure but I wanna say most of there stuff is 70 vg 30pg. I have gotten completely away from clearos for this reason. I always had horrible wicking and always got that burnt taste with any high quality vg heavy juice. Try cutting your juice with just a smidge of water or pg. It should thin down and give you a little better luck.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread