Hey guys....
I won both Black and Silver nova RDAs from Daniel DJLSBVapes a short while back.
Once I got used to the very short squonk travel (for overflow) I find it to be a great little flavor powerhouse.
The Only real issue I have at all is the hex hole for the machine screws that clamp down the coil. I am a major over-torquer on my coils. I have stripped out all of my screws (including 3 of the 4 installed) so that I do not have any spares and Its going to be difficult to remove the installed screws.
So I guess I should post my question now that I have to edit my post to do so... Do any of you know the size (mX/Y) of the screws that it takes? I did use the web-form on their site to inquire, but I do not expect a speedy response.
I won both Black and Silver nova RDAs from Daniel DJLSBVapes a short while back.
Once I got used to the very short squonk travel (for overflow) I find it to be a great little flavor powerhouse.
The Only real issue I have at all is the hex hole for the machine screws that clamp down the coil. I am a major over-torquer on my coils. I have stripped out all of my screws (including 3 of the 4 installed) so that I do not have any spares and Its going to be difficult to remove the installed screws.
So I guess I should post my question now that I have to edit my post to do so... Do any of you know the size (mX/Y) of the screws that it takes? I did use the web-form on their site to inquire, but I do not expect a speedy response.
Last edited:
