The H45 is great but there are two problems:
1) You cannot see the liquid level unless you remove the pod.
2) After you remove the pod and put it back in, you cannot vape straight away because the device is locked on "New coil" and you need to press the + button to be able to vape again.
That can be resolved by simply cutting about 3mm off the top of the case with a dremel or similar cutting device, and sanding it down with the sanding attachment.
It leaves bare aluminum metal but you can blacken it with a black permanent marker or car touch-up paint.
It doesn't affect the rigidity since the pod uses magnets to secure it down and it still has a deep footing after cutting off the top.
Now all you need to do is tilt it left and right and now you can see the liquid move to determine the juice level
1) You cannot see the liquid level unless you remove the pod.
2) After you remove the pod and put it back in, you cannot vape straight away because the device is locked on "New coil" and you need to press the + button to be able to vape again.
That can be resolved by simply cutting about 3mm off the top of the case with a dremel or similar cutting device, and sanding it down with the sanding attachment.
It leaves bare aluminum metal but you can blacken it with a black permanent marker or car touch-up paint.
It doesn't affect the rigidity since the pod uses magnets to secure it down and it still has a deep footing after cutting off the top.
Now all you need to do is tilt it left and right and now you can see the liquid move to determine the juice level
