Getting A LOT of juice in my mouth with the new Subtank Plus RBA. Help?

[paleh0rse]

OK, it's not "spitting" the juice into my mouth. Instead, it's like I'm pulling liquid straight through the entire deck and into my driptip and mouth whenever I hit it.

Notes:
1. This is with the NEW Subtank rba Mini Plus (The one that comes with the Subox).
2. I'm inhaling with the same amount of force I've always used with my STM's.

Would more/less cotton solve this problem? How much cotton should I actually be using in these tiny decks? (I'm always afraid to use too much, and I'm already using more than with the old version).

Thanks ahead of time!

Edit: picture of my build:

 

[d.g.]

Cotton and build looks good. I never used this atty, are the juice holes too large?

 

[MotoMudder]

Flooding is the only thing I can think of, but cotton doesn't look too thin. Are you covering the holes up really good?

Sent from my LG-D851 using Tapatalk

 

[Boden]

I've had this problem. Don't lay it on it's side after you vape, the condensation will run towards the mouthpiece.

 

[paleh0rse]

Cotton and build looks good. I never used this atty, are the juice holes too large?

Flooding is the only thing I can think of, but cotton doesn't look too thin. Are you covering the holes up really good?

Sent from my LG-D851 using Tapatalk

The holes are actually pretty large on this new version. I just re-wicked it with a tad more cotton -- this time using enough so that I could push some out through the holes. It seems to have helped a little, but it's still altering some juice into my mouth.

Frustrating...

 

[MotoMudder]

Yea the holes are large. I leave about .5" sticking out the coil ends. Enough cotton that it gives a little resistance while pulling through the coil.
Also I noticed that using the included cotton seems better than my normal cotton balls I've used forever.
Is keep trying more cotton, if you get dry hits, then too much, spitting at you then too low watts or too little cotton. Just my findings playing with it.

Sent from my LG-D851 using Tapatalk

 

[paleh0rse]

Yea the holes are large. I leave about .5" sticking out the coil ends. Enough cotton that it gives a little resistance while pulling through the coil.
Also I noticed that using the included cotton seems better than my normal cotton balls I've used forever.
Is keep trying more cotton, if you get dry hits, then too much, spitting at you then too low watts or too little cotton. Just my findings playing with it.

Sent from my LG-D851 using Tapatalk

Appreciate the info! I guess I'll just keep messing with it.