Not sure if this is the right forum to ask this and if it isn't just let me know but....I have gone through 2 flush cut pliers and needing another set. The first ones were the pliers that I got in the coil master kit. The problem I'm having is after a while of use they tend to get spots on the blades where the edge gets bent and it won't cut in that spot any longer. The first ones were my fault when I first got into coils building cause I ended up snipping the swivel (I used to cut the wire off the swivel before I started just unbending it from the swivel when I'm done wrapping wire for a coil). The second pair I got was from Walmart in the jewelry making section. The metal they are made from doesn't seem to have a good Rockwell hardness rating cause I have had them for 2 months maybe and the cutting edge is all ragged from snipping wires.
My question is can anybody tell me of any good "quality" flush cut pliers that doesn't cost $50-$80? I tried looking them up on google and it's seems all the quality pliers with a good Rockwell rating are super expensive. Thanks for any feedback!
Sent from my iPhone using Tapatalk
My question is can anybody tell me of any good "quality" flush cut pliers that doesn't cost $50-$80? I tried looking them up on google and it's seems all the quality pliers with a good Rockwell rating are super expensive. Thanks for any feedback!
Sent from my iPhone using Tapatalk