Got my eGo today!

[Trance]

So I received my Joye eGo from cignot today, and I must say it's woooooonnnnnnnnnndddddddeeeerrrrrrfuuull lol. One battery lasted me ALL day at work! Now I must admit I was alittle skeptical that it would be such a significant difference, but Wow! I do have one question though..I seem to need to pull harder in order to get a decent hit, is that normal? Or just the atty breaking in. Not too much harder, but I just need to draw a little longer. All in all though, I love it!

I also got a whooooooolllllleeeee bunch of blue foam..apparently(and I should of thought of this sooner) my parents feed store sells it, in big 1' by 1' squares..so..thats enough to last me..a good while Im guess...Im still a little confused on how exactly to do it..but Im sure I'll figure it down..

 

[LowThudd]

My eGo actuallyt pulls easier than my 510. Try blowing out the atty into a paper towl. Also, there are attys that have only two notches I believe. Check to see if that is the case w/ yours.

 

[Laddsy]

I find using cartomizers a heck of a lot easier. You just fill and go and it lasts most of the day.

 

[Scucci]

I've had a couple of carts that were too tight at the... well, I guess I can call it the .... hole.

There was something in there clogging it. I shoved a paper clip in there, removed the end cap (at the mouth end) and put made sure it's hole was cleared.

Starting hitting easier for me after that.

It should be a LITTLE harder to draw off of, but not too much so. Should feel like about like what a real cigarette would feel like as far as resistance. Just make sure your .... hole is clean and it shouldn't be an issue.

 

[LowThudd]

Also, try some 901 carts. They work much better on the 510/eGo than the regular 510 carts.

 

[CaptJay]

Make sure your atty is seated right - sometimes you need to PUSH as you finish screwing it onto the eGo battery. If it sits a little proud then you havent got a proper connection and its like trying to drink a milkshake through a tiny straw.
To test if its on right, use a blank cart (no filler) and just drip on the atty bridge, then re-attatch and vape. If it pulls easily its good to go and if it pulls too hard when you add filler then your filler is too dense and needs a bit of a 'prune'

 

[combat_medic]

I ended up having to increase the size of the "slits" for air flow in the top of the battery a little to get the draw I wanted. Just time and a small file, the inner brass will show and do not deepen them so far as to damage the threads on the top of the battery. a very small increase in the air "slit" will help the draw a lot, so little file, test, repeat.ensure you clean the threads and the connection from the filings. hope this is useful to someone

do so at own risk