It came in today. Was tracking it like a mad-man. So of course I had to stop at both of the stores that sell ecigs in town, one for a juice I like, another for some new aw button top batteries that I've never needed previously.
I had to wait the whole day, then drive home 2 hours, then run to the shops, then I finally was able to come home to greet the new mod. Lol, some of you would've just taken the day off I'm sure
There are the pics. The first coil I attempted building was a twisted 28awg. To me, that is not possible to reach at my desired .9-1.0 ohms on an era v1.5. It was ten wraps and I could not position it so it wouldn't be a short to the cap. I even tried putting the hot around the center post and in the back-side, that was close, but a little sketchy for me.
Airflow is extremely tight stock on the era. I'm used to dual 3/32 air holes, this is about roughly 3/64(1.2mm) I'd have to say. I may very well be wrong with the era hole, but dang is it tight.
While writing this post I just bought a door, extra bottle kit, and new feed tube lol. I guess the never-ending reo spending has begun.
I had to wait the whole day, then drive home 2 hours, then run to the shops, then I finally was able to come home to greet the new mod. Lol, some of you would've just taken the day off I'm sure
There are the pics. The first coil I attempted building was a twisted 28awg. To me, that is not possible to reach at my desired .9-1.0 ohms on an era v1.5. It was ten wraps and I could not position it so it wouldn't be a short to the cap. I even tried putting the hot around the center post and in the back-side, that was close, but a little sketchy for me.
Airflow is extremely tight stock on the era. I'm used to dual 3/32 air holes, this is about roughly 3/64(1.2mm) I'd have to say. I may very well be wrong with the era hole, but dang is it tight.
While writing this post I just bought a door, extra bottle kit, and new feed tube lol. I guess the never-ending reo spending has begun.
