I've been looking for a way to keep my 1300mah Spinner from rolling and sliding around in my car when I set it down. I thought I was going to have to make something, which I'm not very good at, but as it turns out I had the solution in my juice cabinet the whole time. I just didn't realize it until now.
The foam insert that comes inside the Halo sample pack tins has seven holes in it. Six around the circumference of the insert for the juice bottles and one right in the middle that has a foam insert in it. I removed the middle insert, (exposing the hole) and crammed the foam insert into one of my cup holders in my car.
My Spinner wobbles in the hole when the insert is not crammed into the cup holder but when it is my Spinner fits nice and snug. No wobble even when going over bumps or turning corners.
Both of these batteries are from a different vendor whom I won't mention here out of respect but I'm guessing the Halo Triton batteries would work too. I don't own any yet so I can't say for sure.
I just got back from running some errands and I tested this out for the first time. Worked like a charm. Especially on the wider 1300mah Spinner. It slides effortlessly into the middle hole and stays put even with and Evod attached.
Just thought I would share this in case someone else might want to try it.
Here's the foam insert crammed into my cup holder: (I know, it looks silly)
Here's a 1300mah Spinner (a little fatter than my other batteries) sitting nice and snug in the center hole:
The battery with a smaller diameter does wobble some while driving but it still stays in place:
The foam insert that comes inside the Halo sample pack tins has seven holes in it. Six around the circumference of the insert for the juice bottles and one right in the middle that has a foam insert in it. I removed the middle insert, (exposing the hole) and crammed the foam insert into one of my cup holders in my car.
My Spinner wobbles in the hole when the insert is not crammed into the cup holder but when it is my Spinner fits nice and snug. No wobble even when going over bumps or turning corners.
Both of these batteries are from a different vendor whom I won't mention here out of respect but I'm guessing the Halo Triton batteries would work too. I don't own any yet so I can't say for sure.
I just got back from running some errands and I tested this out for the first time. Worked like a charm. Especially on the wider 1300mah Spinner. It slides effortlessly into the middle hole and stays put even with and Evod attached.
Just thought I would share this in case someone else might want to try it.
Here's the foam insert crammed into my cup holder: (I know, it looks silly)
Here's a 1300mah Spinner (a little fatter than my other batteries) sitting nice and snug in the center hole:
The battery with a smaller diameter does wobble some while driving but it still stays in place:
