Halp! Low resistance error

[jlc767]

Hey guys.

My 722 arrived today and after using it most of the afternoon without any issues, I noticed what appeared to be a crack in the glass. I swapped it out for the stainless steel ring (see below) and after piecing everything together, it's simply not working. I'm getting a "Low RES" error (instruction manual says "low atomizer resistance, <0.5 ohms"). I've taken everything apart multiple times, ensured everything is dry, clear, tight, seemingly good to go... and nothing. So weird! I even swapped coils. Same thing.

Any help would be GREAT.

EDIT: When piecing everything back together I DID manage to leave an O-ring off part of the inside chamber. I've since put it back in place, but... maybe a slight leak caused all this?

EDIT 2: Turning on the device without my Aerotank Giant attached shows a seemingly normal LCD readout. 5.00v, full battery icon and 2.5 ohms at 4.04v. Attaching the tank causes everything to zero out (and the low res error).

EDIT 3: Could have fixed it. I opened everything up and took out the coil. It was screwed in really tight. Put it back in (not as tight, but still snug) and now I'm getting a reading. WEIRD.

 

[realsis]

Sometimes you can get that error message if something isn't right with your coil. What is the minimum resistance your device will run? Most regulated mods have a mimimum resistance cut off. Some mods lower than orhers. The newer mods allow sub ohm some down to .2.