Hands-on with the magoo (Ithaka clone)

[blowingclouds]

$50 for Magoo here: ismoka Magoo-S
And $45 here: Magoo-C RBA from iSmoka

Know where i can get a 510 drip tip adapter for the magoo that is in stock?

 

[nz1001]

Did drilling out the air intakes improve your performance? I run them wide open and the draw is perhaps a little tighter than I prefer. The flavor is spectacular and the vapor production is good if I take long slow sustained draws. I assume that opening up the intakes will increase vapor production, but will the flavor saturation suffer?

...just got back from vacation.
i think it does not help increasing the air flow as the bottleneck is the center post, but the ac-ring can be screwed down a little tighter afterwards.

 

[I'mGatMan!]

I'm running two Magoos and like them very much. The coil build is more complicated/tedious than a kayfun/Russian, but I get great vapor production, and the Magoos run perfectly.

 

[skunk8pe]

I'm running two Magoos and like them very much. The coil build is more complicated/tedious than a kayfun/Russian, but I get great vapor production, and the Magoos run perfectly.

I have a Magoo and am having a hard time getting good results. I am trying to use an RY4 juice with 3mm silica wicks and a 1.8ohm ready wire. My vapor is minimal and anything over 3.8 watts tastes like burnt coil. I am using a sigelei legend....any advice? I have looked for build videos on youtube but I am doing pretty much the same as they are... kinda discouraged....