hard drag on a cartomizer?

[BalkanBoy]

I've gone through a few 5ml tanks on my Boge F16 with a single coil 1.5 ohm cartomizer - and finding it difficult to get a whiff .. is this normal even though the carto is only a few days old, or is there some "fix" for a hard drag cartomizer? Thank you!

 

[SteamDaddy]

make sure it's not tightened down too tight on the mod. so air can still flow.
you may have to change your carto. they don't last too long.
some crap out the first day. if it gurgles take it off and clean the mess on the bottom, and on top of the battery post.
all else fails, try a different carto and tank setup.

 

[BalkanBoy]

Replaced it w/a new smoktech 3.0 ohm, and even tightened all the way down, works like a charm - nice airy draw. Thanks daddy!

make sure it's not tightened down too tight on the mod. so air can still flow.
you may have to change your carto. they don't last too long.
some crap out the first day. if it gurgles take it off and clean the mess on the bottom, and on top of the battery post.
all else fails, try a different carto and tank setup.

 

[SteamDaddy]

your welcome and anytime

 

[SteamDaddy]

also remember wash everything. keep everything clean.
new tanks, heads, wicks.
wash them first and let them dry before using.
left over production chemicals, dust, nasty stuff still on there.
the guy who put your stuff together at the factory may have had a bad day and to the bathroom and didn't wash his hands before he came back to work.
you get the idea.
also helps it wick better, being clean.
clean and wash everything out every couple of days.
keeps it working good and tasting good.