I'm a vape newb. Just got my Kanger Evod 2 starter pack. Cig free for a day now! Since charging the battery for the first time, one of my thingys is much harder to draw from. What did I do and how do I fix it? Did juice get in somewhere it is not supposed to be? I changed the coil and that did not help. The one I took out was discolored (the wick?) but I put it back in the pack since I don't think anything's wrong it. Any help/insight/advice would be greatly appreciated!
Harder to draw
- Thread starter Azulsky
- Start date
- th_trl_thread_readers 0
- Status
Noob here too...
Had to change my habits. Draw of a vape is different. Slow long mouth to lung draws otherwise kanger will leak and spit and gurgle.
Maybe that's the problem...
Had to change my habits. Draw of a vape is different. Slow long mouth to lung draws otherwise kanger will leak and spit and gurgle.
Maybe that's the problem...
Welcome! Drawing from an e-cig is different than drawing from a cigarette. Typically the draw is much slower and longer.
Are you blocking the Evod Clearomizer's air holes with your fingers while holding it? If you hear gurgling noise you may have some juice in the "chimney" of your clearomizer. If so, unscrew the bottom take out the coil (chimney looking device attached to the base) cover it with a power towel and blow out the juice.
The clearomizer typically need a little "priming" when you first load them also It helps to take a couple of puffs without hitting the firing button to get some juice in the wicks.
There are a lot of good "starter" tips on this site, unfortunately I am not currently in a position where I can provide a link.
Congratulations on making the switch, and enjoy!
Are you blocking the Evod Clearomizer's air holes with your fingers while holding it? If you hear gurgling noise you may have some juice in the "chimney" of your clearomizer. If so, unscrew the bottom take out the coil (chimney looking device attached to the base) cover it with a power towel and blow out the juice.
The clearomizer typically need a little "priming" when you first load them also It helps to take a couple of puffs without hitting the firing button to get some juice in the wicks.
There are a lot of good "starter" tips on this site, unfortunately I am not currently in a position where I can provide a link.
Congratulations on making the switch, and enjoy!
Well, I would understand that, and it did take some time to adjust the inhale method, but both are the same model and one has become harder to draw from, the other has not. So it must be something I did. Tho I don't know what. All I've done is refill and charge. Tho I did change the coil as I stated above, to see if maybe that was the prob and it was not. I have been very careful of finger placement, as there are holes in the bottom of battery and the "base". I will try the blowing of the chimney. Thanks
Last edited:
Get an aerotank. I've become an aerotank advocate. A world of difference in flavor
Glad you found the answer!!
It takes a little time to learn some of the "ins and outs" of this equipment, but, that's part of the adventure!!
It takes a little time to learn some of the "ins and outs" of this equipment, but, that's part of the adventure!!
For the coil that has the discolored wick, run it under hot water even through the chimney and then do a dry burn. Youtube has slews of videos showing you how. Coils last anywhere from 1 to 4 weeks depending on the color of the liquid you vape. Dry burning it will extend the wick's usage.
Good luck and welcome to the world of ECF. Congratulations on your new style of living!
Good luck and welcome to the world of ECF. Congratulations on your new style of living!
When the wicks become gunked up this too may cause some blockage of the air passage. Time to replace wicks (ar coils if you rebuild your own).
Go to YouTube and check out some videos. They provide great, easy to follow directions for about anything involving the equipment...
https://www.youtube.com/results?search_query=dry+burning+coils
My first dry burn almost set the wick on fire. Been practicing since. A must do after vaping darker juices... coil extender for sure
[I
[I
I chain vape. But then again I walk around with 3 flavors for variety so it gives me cool down time but usually get better flavor when it heats up
Sent from my SM-N900V
Sent from my SM-N900V
The new airflow works on the two asWell got so e for the one , two and there's after using an airflow tank I just had to get them.
- Status
Similar threads
