Has anyone figured out a way to plug that vent hole on the mini RDA

[LeoRex]

I recently picked up a 'Squid' mini rda.... a device that would work great as a little dripper if not for the fact that the vent hole is drilled so it's pretty much even with the deck.... any juice not wicked up ends up dribbling down the side.

Problem is that it's microscopic... less than 1mm... I had one of those little silicone plug things that come in the bottom of some of those cart condoms.... even that was too wide.

 

[dr g]

maybe some high temp epoxy like jb weld OR you could drill it out big enough to plug

 

[Harlen]

Metal tape works

 

[st0nedpenguin]

Wouldn't filling the hole result in zero airflow?

 

[LeoRex]

Wouldn't filling the hole result in zero airflow?

Going to drill a much larger one higher up to clear the deck and get closer to the actual coil. I'd like a kind of drip well, of sorts.

 

[Rmcgloth]

I left mine open, drilled a hole in the top ring. Good lung hitter. I have heard people jam a toothpick in the and slice it flush with an xacto knife. The flavor is good the way I set it up, as air is hitting the bottom and side of the coil. It does leak if I over drip, though.