Hey ya'll! My husband has an Itaste MVP 2.0 and multiple tanks that all work well with except for his Kangertech Evod tank. It screws on and fits just fine but it's nearly impossible to hit. Anyone know why or have a solution to this?
Hey ya'll! My husband has an Itaste MVP 2.0 and multiple tanks that all work well with except for his Kangertech Evod tank. It screws on and fits just fine but it's nearly impossible to hit. Anyone know why or have a solution to this?
I did the same thing. The MVP (while it's a great little battery) is notorious for having a low firing pin and being a pain in the back side. But for its size and battery life I got over it.
Just pull the pin down a hair in the evod and make sure not to over tighten in the future and you should be good to go If the MVP's pin was compressed you can pull it up a hair as well, but be *very* careful if you chose to pry that one up.
Make sure tanks are just finger tight and the issue will stop
Creepylady's suggestion of pulling the tank's atomizer center pin should get your hubby going again. The center pin should be pulled out less than a fingernail thickness distance to correct the problem.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.