Hello from Kansas!

[Jdubs]

So i have been researching the procolor and its a moderated VW setup with an operable ohm range of .1 to 3.0 ohm. even tho i missed my target resistance of .415 ohms, will i be ok with my dual coils at the .35 ohm in my new dotmod petri rda clone?
Sorry for all the noob questions. Im reading a lot of info and im thinking it should be ok but i wont move forward until i hear from more experienced builders. I want to make sure im understanding this right. Thanks!

 

[stols001]

If your mod will read them, it should be fine (and at 0.1 lowest resistance, they should). The real question will be how your batteries hold up and what wattage is going to work for that coil, but you are actually not TERRIFICALLY far off your target value, so I'm thinking unless you are overstressing the mod by vaping at insanely high wattages (near the top range of the mod) you should be fine. There's no harm in priming it and working your way up in wattage to a reasonable vape for you.

With that said, what's the top range of your mod, and what batteries are in it? That's important information to know, but I'm not seeing your slightly lower resistance as a TOTALLY huge problem, provided it's not overstressing your mod (I don't know much about the procolor, but with decent batteries, I am thinking you should be fine). What target wattage did you have in mind based on your earlier build?

Anna

 

[Jdubs]

If your mod will read them, it should be fine (and at 0.1 lowest resistance, they should). The real question will be how your batteries hold up and what wattage is going to work for that coil, but you are actually not TERRIFICALLY far off your target value, so I'm thinking unless you are overstressing the mod by vaping at insanely high wattages (near the top range of the mod) you should be fine. There's no harm in priming it and working your way up in wattage to a reasonable vape for you.

With that said, what's the top range of your mod, and what batteries are in it? That's important information to know, but I'm not seeing your slightly lower resistance as a TOTALLY huge problem, provided it's not overstressing your mod (I don't know much about the procolor, but with decent batteries, I am thinking you should be fine). What target wattage did you have in mind based on your earlier build?

Anna

Thank you so much for the reply! My mod is being powered by 2 3000 mah HG2 rated at 20A. I was just shooting to replicate the factory tank coils at .4 ohms which are listed as good between 40-80 watts. This mod can go over 200 watts but i generally vape between 100-120 watts depending on what factory coil is in there and the listed "best" range on them. I doubt ill ever go higher than that.

 

[stols001]

Sounds to me like you should be okay. Take note of the number of wraps and etc., to see if you can get a bit closer, but it sounds like your setup can handle it.

Good luck!

Anna

 

[ExtremeDooty]

Hi Jdubs. I drove through Kansas once.

 

[Jdubs]

Sounds to me like you should be okay. Take note of the number of wraps and etc., to see if you can get a bit closer, but it sounds like your setup can handle it.

Good luck!

Anna

Ok awesome thanks so much!!