Hello!

[LaGlock]

Hello to all! I have started using a VaporX XPS, picked up the starter kit about two weeks ago. I'm sold so far! However, I have a question....What is the proper name for the tanks that the liquid is placed into, and how do I clean the tank without damaging the wicks, and what I think is the atmoizer or heating element? I messed my first one up after cleaning it a few days ago, so that when you put the mouth piece on it didn't "sit" on the clear rubbery piece, resulting in almost no vapor being produced and a hard "pull." Any help or advise would be greatly appreciated!

 

[InTheShade]

Hi LaGlock and welcome to the forum. So let me try to answer a couple of your questions.

Most people call the tanks that sit on top of the battery a topper. There are different types of topper but in your case it's a clearomizer (or clearo for short)

Best way to clean a clearo is to take it apart as much as possible and rinse under hot water. Do this every few refills and you should be able to extend the time between replacing them by as little as a few days, or as much as a few weeks. I know you said you did this and now it doesn't work - but I think that is because the clearo you are using is just not very good (sorry!) Most clearos can take a lot of rinsing and cleaning before needing to be replaced.

I've been trying to find a diagram or a picture of the inside of your clearo so I might be able to help with getting it working again. If you or anyone else has a picture of it, please post up. It's impossible to find online as all I have to go on a a small photo of the device in a blister pack.

 

[Susan~S]

Hello and welcome to the forum. Glad to have you here!

 

[djsvapour]

Hi!

I googled Vapor-X XPS and found this. I don't know if it is still relevant.

http://www.e-cigarette-forum.com/forum/new-members-forum/479943-i-vapor-x-xps-kit-trap.html

Be careful out there. I'm sure it works OK, but not all products are equal.