Help/Advice Rebuilding TF-RTA G4 Deck?

[PSiKoTiC]

I have both the G2 and G4 decks. I've ran into something odd that I haven't before. It won't fire. at all .. I've tried it on my Hohm Wrecker box mod, Sigelei 213w and a sigelei 150w (old) and a releaux box mod.

It was working perfectly with stock coils, wicked up no issues.. vaped great. Went to rewick it .. about 2 weeks in to use. My Hohm wrecker reads 'Connect atomizer' so I figured I shorted something or a connection was perhaps lost. Fiddled around with it.. nothing.. so screw it.. cleaned the whole thing junked all the coils. For consistency sake I've used pre-wrapped clapton coils. Hohm wrecker.. still won't fire 'Connect Atomizer'.

Now here's where I'm confused. on the Sig 213w it fired. Tried to fix hot spots etc (there was a short on one of the legs by the connection, figure this is why it was reading 'check atty' on the other box mod) Fixed the hot spot.. then .. Sigelei 213w telling me to check atomizer now aswell.

At this point I connect it to my ohm reader..

SmallerIMG_20160617_121218__1466187477_68.147.166.86

• PSiKoTiC
• Jun 17, 2016

Smok TF RTA G4 Deck on Ohm Reader

0.27 reading.. odd. (0.5 ohm coils (approx) quad coil. Something not right here.
Despite this.. It will not register on any of the mods I listed. Any suggestions?

 

[silentseeker]

Try to push the top of the deck down till you hear a click. Happens to mine too. the 521 tab pushed too hard from the pin and it slacks about .5 mm

Sent from my ASUS_Z00AD using Tapatalk