so I recently picked up a Stillare clone at my local shop. I'm new to rda's so I bought it because it was cheap. Only $18. I love this thing with a 28g .6 dual coil build! I really want to try a single coil build but there is only a dual air hole option. What's the best method for drilling out a 3rd hole on one of these bad boys?? Any help would be greatly appreciated!
Help! Drilling out RDA
- Thread starter MikeyFairfax
- Start date
- th_trl_thread_readers 0
- Status
Drilling out a 3rd cyclops hole or just a hole in general, is going to be impossible or very difficult, since it is a 3 piece dripper and the air flow is controlled by a second piece sitting behind the middle cap and I doubt it would look good. The only way it might be possible is to do some serious measuring, and calculating. IMO it would be a lot easier and look a lot better to pick up an RDA designed for single coils.
Thanks for the advice. I wasn't going to drill it out but tonight I was bored and did it anyway lol. I guess I'm a little hard headed! I drilled 3 holes as close together as possible in the inner airflow control cap. It surprisingly turned out better than I anticipated and I'm enjoying a single 3 strand parallel micro coil at .4 ohms. I'll post pics when I figure out how haha.
- Status
Similar threads
