help me :(

[blondie1964]

im going to build variable volt mod.
and got parts from Madvapes (kit2)
i have looked every where for diagram to wire it.
and the diagrams i have found are not easy to follow.
or do not go with the kit i have purchased. i have everything needed to do it.
the little diagram that mapvapes has doesnt show everything, just how to wire to board.
could someone send me full diagram, on how to wire whole mod.
its got to be easy explaining, due to im a girl, lol
i have made mods before, but only 3.7 mods. so i know alittle about wiring and solding.
thank you so much
Lisa
parts im using.....

 

[ejoker]

moved to the madvapes sub

 

[breaktru]

moved to the madvapes sub

What's the madvapes sub?

 

[blondie1964]

thats vet's answer? ok

 

[lynch]

Go to mv's site and click on "help" top of page, then you will see how to make a 5 volt mod.
Just seen you wanted to know about a variable volt, sorry dont see any for them.

 

[kcofohio]

Variable Voltage Regulator Board Kit Rev 2

The 2nd product pic shows a rough sketch of what wire goes where. R1 will connect to 3 & 5, R2 will connect to 1 & 3. Hope that helps.

 

[dragit]

chick into buildin shizzz.. That is way cool

 

[prometheus]

Good luck finding one. I have been looking for a while now. I ended up tossing it and buying a pre-built one after toasting it through trial and error lol.

 

[MASTER0FDAMPF]

From some looking at thing (I have not built one using these parts yet) build the board. Build the mod as if you were building a 5v but connect the board in place of the 5v regulator.

For the LCD readout connect it after the board between it and the atty if you want to see the adjusted voltage.

 

[lynch]

If your still looking go to youtube and steeljan has a bunch of video's and one of them is
"How to make a variable volt mod" 22 minutes long. If you skip to about the 11 minute mark
it might be all you will need.