HELP not getting any vapor Davide King BDC

[dadeblunts]

Changed flavors last night and now am not getting any flavor. Did i do something wrong putting this thing back together? Got a few pulls last night then nothing, changed the atomizer heads and still nothing. Suddenly got a few more good pulls and thought everything was ok, this morning getting nothing. When i take the tank off and have just atomizer screwed in i can see it heat up.

What did i do wrong?

 

[dadeblunts]

Just opened the tank, fiddled with rod thing that comes up into the mouthpiece and now its hitting right again. ... did i do :/. Would like to avoid this in the future. Anyone with this tank can chime in?

 

[hondo11]

I'm a newbie, but ran into the same problem. Try loosening then re-tightening the stem of the atty. Recently bought two of the Mini's. Like the design but not the fading favor or loose tips which I often remove to retrieve the flavor.

 

[cbrite]

Also be careful not to screw your tank on too tight because that will stop the airflow.

 

[dadeblunts]

I got an AFC, even without it there is plenty of gap under the tank for air.

 

[Maestro]

Get a tiny screwdriver or tweezers and pull out the bottom of the atomizer a bit where it sticks out the bottom of the tank. It's kind of spongy and sometimes doesn't make a good connection.

 

[dadeblunts]

Atomizer is firing. its like i get no juice to it tho sometimes

 

[Maestro]

Make sure the plastic dish at the bottom is turned so the holes are showing. And try unscrewing the fill insert (not just the drip tip) to release the vacuum so that the liquid can flow into the bottom chamber.

 

[joecil]

To fill it from the top, when you turn the rod through the center it turns of the flow from the bottom. Now it must be open to work but not when filling. If you take off the bottom part and look at the two holes and see what I'm talking about. You can fill from the top or bottom though the bottom must be closed off while filling from the top.

 

[hondo11]

Not sure if other problems will arise but they both work like champs since I removed the rubber hat or grommet from the wicking area for lack of proper terminology. Thanks everyone!

 

[dadeblunts]

Make sure the plastic d the bottom is turned so the holes are showing. And try unscrewing the fill insert (not just the drip tip) to release the vacuum so that the liquid can flow into the bottom chamber.

Was this. I feel ......ed as hell lol. Took it apart then noticed this. Upset I'm ......ed, glad was an easy fix

 

[hondo11]

Was this. I feel ......ed as hell lol. Took it apart then noticed this. Upset I'm ......ed, glad was an easy fix

I'm worse than you! Just went and bought two more of these contrary contraptions.

 

[cjsmiley13]

The Davide king- top or bottom fill better? Suggestions?? Thanks