Help please

[Susan2014]

Hi, I am using a Kanger mini protank 3. It leaks and I have read and watched a lot of video's. I have found out that If I use two of the little rubbers near where the wick comes out it stops the leaking. Now I have seen these little rubbers on some website but I can't find it again. Does anyone know where I can buy these? Thank you for any help.
Susan

 

[joesquid]

No need for rubbers.....Are you using stock coils? Where is it leaking from? Check to make sure the o rings are in the channels on each cap to seal the glass.

 

[Bunnykiller]

next time you get some new coils, save the seals from the old used up coils....

 

[Kim B.]

I have some mini PT3s and so far, no leaking issues. One thing you could try: After filling tank but before putting it back on your PV, hold a paper towel to the bottom of the mini PT3 and gently blow through the drip tip, could be that some juice leaked into your middle tube, if so, this should fix it, blow gently until no more juice leaks from the bottom.

 

[Susan2014]

They all have the o rings it seems to leak out of the bottom and then onto the battery. It also will spit e-juice into my mouth. When I put the extra rubber on it I put it upside down on top of the other one. Sometimes I due trim it out some. This takes care of all of the problems. I just wanted to find out where to buy extra's. I have used the ones from the coils that I have not rebuilt.
Susan

 

[Kim B.]

Here's a solution from another ecf member: http://www.e-cigarette-forum.com/forum/general-e-smoking-discussion/489833-kanger-coil-grommet-fix.html

 

[Susan2014]

That helps a lot. Thank you very much.
Susan

 

[Wow1420]

Are you using the single coil replacements in your mini PT3 ? or the dual coil ones?

 

[Kim B.]

You're very welcome.

 

[Boiler]

These things?
Silicone Top Caps for Protank / Evod Style Coil Heads - Lightning Vapes

 

[Susan2014]

Yes those are the things I was looking for. The others will be cheaper and easier for me to get. I use a double coil in the protanks. We have about 8 of them and out of 8 at least 4 to 5 have leaked. I don't rebuild the double coils as I am new at all of this and just getting steady with a single coil build . Thank you all for the help.
Susan

 

[Rickb119]

If you're comfortable rebuilding single coil heads, you might try replacing the flavor wicks with some cotton. I've found that leaking/gurgling is usually the result of not enough wicking material.