Can I use my aw imr 18650 1600mah batts with my ipv d2 nickel coil. 15 ohms?? I am a little confused.
Help with aw imr 18650 1600mah
- Thread starter Spartiatis
- Start date
- th_trl_thread_readers 0
- Status
Keep it below about 65W (not sure what that is in joules) and your 24 amp CDR AW should be happy. Not sure how your run time will be, but I know no reason to be concerned for safety with those batteries.
You're probably wondering how it can be safe to push a .1x ohm coil when that would mean pulling more current than your battery can safely supply. The answer is that you aren't pushing battery voltage straight through the coil. The mod regulates the power to the coil, so your power setting determines what's pulled from the battery. We can discuss the math for that, but it'll be easier to head to Steam Engine | free vaping calculators and check out the battery drain calculator.
You're probably wondering how it can be safe to push a .1x ohm coil when that would mean pulling more current than your battery can safely supply. The answer is that you aren't pushing battery voltage straight through the coil. The mod regulates the power to the coil, so your power setting determines what's pulled from the battery. We can discuss the math for that, but it'll be easier to head to Steam Engine | free vaping calculators and check out the battery drain calculator.
Thanks for your reply. I guess I was a little confused because of the temp control. I've noticed that when I am using the aw's with my ipv d2, the battery symbol shows it draining when I hit the fire button. Then goes back to normal when I release it. That doesn't happen with my Samsung 25r's
If your Samsungs are a higher capacity (or lower internal battery resistance) than the AW 1600 then that greater capacity can hold up the Samsung's voltage when firing. This can keep the battery display from dropping.
Its weird then cause mine does it with 25Rs, LG HD2s everything Ive put in it. Doesn't drop all the way till the battery gets a little low but it does drop. I only use mine in TC mode. Maybe its the preheat. I don't know
Don't know either.
I would normally say that every battery would do it, depending on the amount of current being drawn. I think your mention of preheat could be important. There could be a decent difference between the accuracy/tolerance of the hardware used to measure battery percentage (probably the voltage, or partially based on voltage) between units.
Ok, so I just put a fresh LG HD2 in and switched tanks to a .5 kanthal coil and it barely drops. Switched back to NI on same battery and it drops almost halfway. Preheat must have some influence
- Status
Similar threads
