Help with BF RBA

[ChelsB]

Again confusion! Sorry, lol - no I don't think YOURS is a fake.
Vapdivrrrrrrr identified the squonking atty in MY picture as an "M Atty" - which is one of those weird over-hyped products that people could only get if they were some kind of royalty, or willing to pay someone $800 on eBay, etc. So I was clarifying that my M-atty is not a real one, but a clone.

(I DO have an authentic NarDa - but got it at a very reasonable price from an honorable ECF-er who just wanted to sell not to profit).

This probably wouldn't have been as confusing were it an in person conversation[emoji4]

 

[ChelsB]

Anyone have any more suggestions or advice?

 

[wheelie]

@ChelsB - Don't waste your time on them heads as it is much easier to rebuild the regular coil heads. Build your coil with a lead on both sides. Bend one lead strait down off bottom. The lead now at the top bend down also with enough room to get a strip of cotton under the lead and on top of the coil. With jig or screwer drive still in coil wrap rest of cotton around coil really tight. Leaving screw driver in coil put legs first and slide it into the animizer. Then negative lead that came from the top and cotton around it bend it over. Put rubber in and bend over positive on outside of rubber and put pin in. Regular coils are easier then the rebuildable. I have 5 rebuildable and I hated them. Vertical coils you can make air space up the middle any size you want. If you coil has that little metal chimney piece in it pop it out with a little blue screw driver. It is not needed as cotton pads wont spit. .5 has the screen in them not the metal chimney. I don't even replace the screens. CHEERS!