Help with E-Cig Setup

Status
Not open for further replies.
Hi all, I have a quick question about the current setup of my E-Cig.

I currently have an Aspire CF G-Power 1600mAh - 4.2v battery with an Aspire ETS clearomizer which has just has a new Aspire BVC 1.8ohm coil put in.

It has recently started to leak alot more than usual and I cannot figure out why. There is no reason why it should be leaking as it has never been dropped or left on its side and its been fully charged.

Can anyone shed any light on this.

Thanks.
 

Sir2fyablyNutz

ECF Guru
ECF Veteran
Verified Member
Jan 22, 2015
12,126
16,654
66
West Virginia, USA
Hi JayPower and welcome to the forum. I have had the occasional leak from my Aspire ET-S, usually when it gets hot from continuous vaping. Take it apart and make certain the coil is cleanly installed if it's not a heat related issue.

If that fails, look at upgrading to the nautilus Mini, you'll love it.

Good luck.
 
Thanks for the advice. Thinking about what you said it does do it mainly whilst in use or after It has been used. I am new to vaping so I havent really got a clue about most of things I read online, but I am looking at the Atlantis 2 but I have annoyingly got a get a new battery with it as it has a 510 connector from what I have read.

I Looked at the Nautilus a while ago but like I said as I havent got a clue about most of these things I just opted for the one I have now.
 
Status
Not open for further replies.

Users who are viewing this thread