Help with my MVP 2

[niko69]

So, I noticed that I can't use Kanger EVOD on my MVP 2 as firing pin is not connecting so I am trying to buy adapter. Do I need ego battery to 510 or 510 battery to ego connection - or it's the same thing??


Thanks

 

[ECURiley]

pull the pin on the evod head, the part that is below the white/yellow rubber piece, it will slide out easily, leave a little room then put the evod on the MVP and it should work with no problem, if this does not work take something and try to pull up the center pin in the MVP, but try the evod thing first. I have to pull the pins on my evods a lot, they just get pushed in when used on other devices. You might not want to tighten everything down so much on your mvp, the pin is not floating, it is pressed in, just finger tight your attys on every device, hope this helps, no need to waste money if you can use a simple fix

 

[niko69]

Tried that already, didn't work...what are the tanks that fit MVP 2 except for I 30?

 

[CrackerTeg]

Take a look here: http://www.e-cigarette-forum.com/fo...e-mvp-v2-owners-group-compiled-list-tips.html

 

[olefolks]

I just got a MVP V2 on Monday and I have an EVOD on top as I type. In fact, I have two EVODS that I have used on the MVP without any problem.
Is the EVOD head screwed in tight? Just saying.

 

[Empi666]

This has happened to me a few times with the EVODs. I just pull the pin out a little on the EVOD and it works. This usually happens when my wife had been using the tank on her eGo.

 

[Baditude]

This is a relatively common issue with the MVP.

The connector well which houses the center pin is designed to be too deep for those juice attachments which use the "ego skirt" (ie iClear 16, Kanger Evod, Aspire CE5).

I've also found that the center pin is too loose and can be easily pressed in by the juice attachment connector if one over-tightens the connections. It can happen even if you don't over-tighten.

The fix is to have a small jeweler's flat head screwdriver and to gently tease the center pins of the connectors so there is more exposure for a better electrical contact.

 

[Peepaw]

pull the pin on the evod head, the part that is below the white/yellow rubber piece, it will slide out easily, leave a little room then put the evod on the MVP and it should work with no problem, if this does not work take something and try to pull up the center pin in the MVP, but try the evod thing first. I have to pull the pins on my evods a lot, they just get pushed in when used on other devices. You might not want to tighten everything down so much on your mvp, the pin is not floating, it is pressed in, just finger tight your attys on every device, hope this helps, no need to waste money if you can use a simple fix

I would have thought one of these would work. You say it didn't, then there is something else going on here.
My evods work like a champ on my MVP. Haven't had to adjust/monkey with anything yet.

 

[milescadre]

yea the mvp has a free floating (somewhat) center pin which some tanks can smash down. unfortunately cuz theres virtually no standards in making these things, some pins stick down more than others on tanks.

I find its best to always adjust the tank to the mod when possible. and never over tighten. I accidently pulled that center pin up too far on my mvp and actually ripped the positive off it! so far, a little scotch tape and a disassembly fixed it, but I always livei n fear that the connection wont be secure.