Help with the Mutation X V4

Status
Not open for further replies.

BMacR

New Member
Sep 8, 2014
1
0
Nh
4906621e1506aae8edabbee93d47c252.jpg


This is my .03 ohm 6 wrap 26g dual twisted Kenthal build with Japanese cotton. I run it on my 50w istick and I love it. Running Hobo Joe's Grime on a daily and it's amazing I love this mod, rda and juice.

Be careful with the painted X V4's mine was white and I ended up stripping the paint, came off with a little acetone and it's much better now..... No one likes paint in their lungs.

Aside from that I close all the upper holes and run just the bottom feed about 1/4 and it's warm, definitely flavor chaser but with the air holes open it chucks clouds even with them closed the production is great.
 

Dipper926

Senior Member
ECF Veteran
Nov 27, 2014
153
87
North Carolina
Hey! Looks like when I first tried. And yours isn't scratched to pieces like mine is.... 3 weeks later. Here's what I did, same atty, same wire. I built to .4 or .5 and spaced my wires a bit. I soak it till it leaks slightly, puffed until it was rolling a bit, desaturated the heck out of it. After that I could hit 40 watt hits about 5 times prior to it becoming dry again, also, trim the wicks more, increase wire spacing and trim the wicks a bit. Helped me significantly, at least til my lower gauge wire comes and I can do more spaces and more wraps. Good luck!


Sent from Tapatalk.
 

Dipper926

Senior Member
ECF Veteran
Nov 27, 2014
153
87
North Carolina
4906621e1506aae8edabbee93d47c252.jpg


This is my .03 ohm 6 wrap 26g dual twisted Kenthal build with Japanese cotton. I run it on my 50w iStick and I love it. Running Hobo Joe's Grime on a daily and it's amazing I love this mod, Rda and juice.

Be careful with the painted X V4's mine was white and I ended up stripping the paint, came off with a little acetone and it's much better now..... No one likes paint in their lungs.

Aside from that I close all the upper holes and run just the bottom feed about 1/4 and it's warm, definitely flavor chaser but with the air holes open it chucks clouds even with them closed the production is great.
I do the same airflow... Bottoms only usually.

Can you recommend a good driver to wrap twisted wire? I know nothing about drills so I don't know which has the slot things for wire.

Sent from Tapatalk.
 
Status
Not open for further replies.

Users who are viewing this thread