Ok, so here i go at my first vv mod. Just went to RatShack and got me some crap.
1 1k ohm resistors
1 270 ohm resistors
1 1.5 amp switch (button)
1 lm317t regulator
1 10k pot (5 pin though???)
Also i already have alot of odds and ends laying around.
My question is this, if i use the 10k pot as R2, should i then use 3 1k resistors in series as R1?
Have i wasted more money on this pot?
Should i put my soldering iron away for good?
The goal here, is to make a 2x 18650 vv mod using parts on hand. My fistpack charging port is screwed up, and untill i attempt to repair that little gem
(yeah right), i will try to make my own.
Also on a side note, i am probbably just going to rip the guts out of the fistpack, and stick them into a wood mod. Also going to make the battery user removable.
Please all you electro wizzards out there, help out a noob here.
Thanks in advance!
1 1k ohm resistors
1 270 ohm resistors
1 1.5 amp switch (button)
1 lm317t regulator
1 10k pot (5 pin though???)
Also i already have alot of odds and ends laying around.
My question is this, if i use the 10k pot as R2, should i then use 3 1k resistors in series as R1?
Have i wasted more money on this pot?
Should i put my soldering iron away for good?
The goal here, is to make a 2x 18650 vv mod using parts on hand. My fistpack charging port is screwed up, and untill i attempt to repair that little gem

Also on a side note, i am probbably just going to rip the guts out of the fistpack, and stick them into a wood mod. Also going to make the battery user removable.
Please all you electro wizzards out there, help out a noob here.
Thanks in advance!