Help

[Ndschreib550F98]

Hi, so a few days ago i picked up the itaste vv v3.0 and an iclear30 (bottom fed) and worked pretty well but i wanted to try the top wicked i clear30, so i bought it and out it on my v3.0 and straight out of the box it did not fire up, the oms reader is saying none. The battery works well with my other tanks just not working at all with this one, anyone know why and or have a solution? Thanks for the help

 

[aaronc940]

how do i bring my ohms down from 2.0-1.8 ive tried bringing volts down & watts?

 

[ProjektMayhem]

how do i bring my ohms down from 2.0-1.8 ive tried bringing volts down & watts?

You should start your own thread on this. But it depends on if you have something rebuildable or not. If not you have to buy a coil head with a lower resistance. There is no option to change your resistance on any ecig mod.

Hi, so a few days ago i picked up the itaste vv v3.0 and an iclear30 (bottom fed) and worked pretty well but i wanted to try the top wicked i clear30, so i bought it and out it on my v3.0 and straight out of the box it did not fire up, the oms reader is saying none. The battery works well with my other tanks just not working at all with this one, anyone know why and or have a solution? Thanks for the help

It could be DOA. Or it could be that the pin on the tank isn't making connection with the positive pin in the itaste. With those types of devices that have a spring loaded positive pin like the itaste vv it can get stuck down in there if you tighten down a tank too hard. If that's the problem all you have to do is CAREFULLY take a small screwdriver or something and pry it back up a little bit. Also make sure the coil head inside the tank is tightened down all the way. I hope this helps you.

 

[Susan~S]

Hello and welcome to the forum. Glad to have you here!

As PM said, sounds like the center pin of the battery is not making a connection with the atomizer of the clearomizer/tank. This usually occurs from over-tightening the tank onto the battery connector. Just make sure that if you use something conductive (metal) to pry up on the center pin that you do NOT hit the fire button while you are working on the battery. Or better yet, turn off the battery.

Center Pin Issue - Fixing a non firing eGo battery

 

[joesquid]

Welcome to ECF! You should have your issue resolved if you followed the advice above. Be careful not to over tighten your tank. Just screw down until you feel slight resistance.