Herakles spitting, how to fix?

Status
Not open for further replies.

drinkmixer84

Full Member
Jun 7, 2013
36
13
las vegas
So I've got a Herakles that I've been loving but recently I'm noticing an issue. After a few vapes @45-55 watts the atomizer becomes hot and I believe what is happening is the juice is thinner so it over saturates and i start to get juice in my mouth on inhales. Once it cools down it vapes fine again (for a few hits).

Any suggestions to resolve this?

Edit: I've also tried a fresh coil and still the same results
 
Last edited:

drinkmixer84

Full Member
Jun 7, 2013
36
13
las vegas
Well I figured out the solution...So turns out Sense ninja released the Herakles v2, I found a local b&m had one in stock (they didn't even realize they had v2s).
The v1s have a single air hole cutout on the bottom, v2s have two, other than that they're identical.

With the 2 air holes the tank is now perfect. Even after that I'd still recommend this tank to anyone and everyone, it's a much better tank than the other options currently available.
 
  • Like
Reactions: nopoison

Joey Frazier

Full Member
May 14, 2015
17
1
37
Columbus, Ohio
How about this for a twist :pop:, i just got the herakles v2 " dual air holes :)" a few days ago and its awesome BUT my only issue is the spitting which is bad and using up alot of juice, also a side twist is its happening regardless of wattage, unless i drop it all the way down and happens when the tank is cold or hot "alot worse thor when hot"
AND i only use and make as high of vg juices as i can :), enjoy. Really apprecieate any ideas.
 

drinkmixer84

Full Member
Jun 7, 2013
36
13
las vegas
So i've had my herakles for a couple months now, I still love it, but one thing i found that really reduces the spitting is using the 0.2 coil. I have an IPV2 and I run it from 68.5 to 70 watts with the 0.2 coil. I also use 80vg/20pg juice which seems to be the best for resolving the spitting issues. I would definitely recommend a wide bore drip tip, as smaller bore drip tips really cause the spitting issue. Also my last trick is i never use the wide open air flow selection, i use the selection just smaller than max air flow (clockwise of max air flow, if looking down the drip tip).
 
Status
Not open for further replies.

Users who are viewing this thread