Well i'm new here, I have to make my 5 required posts so i can get some advice on my nautalis mini, it replaced my ProTank 2 and its been nothing but problems, but hello
hi im new here
- Thread starter Candle_86
- Start date
- th_trl_thread_readers 0
- Status
oh yea, first coil i got with it fine, it went about 3 weeks then got that terrible taste, put in the other coil it came with and it wont wick, bought another coil same problem wont wick. I have the inhouse juice from my local store, used it fine in my ProTank for almost 2 years without an issue, its 50/50 but i just cant get this tank to wick. If I want a hit i literly have to put a few drops directly onto the atomizer to get any nicotine at all.
I've tried to clean the tank, both with water and with 97% isopropyl alcohol which again I used on my Protank without an issue. I've tried making the tank not as tightly screwed down, making it as tight as possible, inbetweens, I'm really getting upset at it.
Hi and welcome to the forum.
Are you priming the wicks of the new coil before screwing it all in to the tank? Putting a few drops of juic on the wicks and allowing it time to soak up before firing will help with that usually. Even taking a few dry pulls on the tank without firing can help as well.
Are you priming the wicks of the new coil before screwing it all in to the tank? Putting a few drops of juic on the wicks and allowing it time to soak up before firing will help with that usually. Even taking a few dry pulls on the tank without firing can help as well.
Welcome here!
I really use drippers the most.
So i couldn't offer any help.
Good luck, hope to see you around here.
I really use drippers the most.
So i couldn't offer any help.
Good luck, hope to see you around here.
Hey, welcome! Is your airflow clogged inside? Or maybe you got some clone coils? That sounds really frustrating and weird. Hate to hear it
On nyour next coil replacement, try taking a pin and "roughing up" the cotton in the four juice flow holes before installing the head.
- Status
Similar threads
