I'm a newbie to this forum. I'm after some help if possible. Voopoo Argus Air bought in October 2020. No problems with it till today. I've changed the relevant coil and it's now not drawing at all. I've cleaned everything with a dry cloth, switched off and on again i have this on the LED light on the display.
Hi
- Thread starter Blakeysmummy
- Start date
- th_trl_thread_readers 0
- Status
Hi @Blakeysmummy, welcome to ecf.
I'm going to hazard a guess and say you might have a dud of a coil there.
You might check it against the old coil.
Hi and welcome to the Forum - I've no experience with that particular set up but I'm sure someone will be along soon to help out.
Thank you, I'll give it a go tomorrow. I tried another new coil and same message, check atomiser. Grrrrrrrrr. Thank you again for replying. Much appreciated x
Is this a new box of coils? They may all be duds. Another fix might be to update the firmware of the mod. If you dont have the user's manual on how to do this, try to find a YouTube video to help you.
Could be your 510 pin on the device is stuck. More likely the coil has been installed too tightly.
You probably already checked, as you said you cleaned everything with a dry cloth, but check the contacts in the mod where the pod plugs in, a piece of lint could be keeping it from making good contact there.
Welcome and glad you joined.
Suggest re posting question to folks who most likely would have an answer:
Voopoo
- Status
Similar threads
