How do i get rid of the burnt tase in my attis??

Status
Not open for further replies.

koskey06

Full Member
ECF Veteran
Jul 26, 2009
15
0
37
fredericktown PA
I have about 10 dse801 attis low an high bridge that have a nasty burnt taste even right after i drip. I tried soaking in 95% alcohol over night an it seemed to fix the problem but then about a hour later its back. Is there a trick to prevent thins from happinging o new attis i use or is the a easy fix to get rid of this burnt taste??
 

sjohnson

Super Member
ECF Veteran
Nov 12, 2009
524
13
I do the burn technique as part of the cycle of cleaning my atomizers. This leaves a burnt taste. So, I pop it into my ultrasonic cleaner filled with water. 5-10 minutes later the burnt taste is gone.

I do:

1. 5-10 minutes in ultrasonic cleaner/water
2. Let dry 1-2 days
3. Do a burn off
4. 5-10 minutes in ultrasonic cleaner/water
5. Let dry 1-2 days
6. Prime with 5-6 drops juice

Sounds like a lot of work, but I have maybe 3 minutes total time invested in cleaning the atomizer and it's clean, like new.
 
I do the burn technique as part of the cycle of cleaning my atomizers. This leaves a burnt taste. So, I pop it into my ultrasonic cleaner filled with water. 5-10 minutes later the burnt taste is gone.

I do:

1. 5-10 minutes in ultrasonic cleaner/water
2. Let dry 1-2 days
3. Do a burn off
4. 5-10 minutes in ultrasonic cleaner/water
5. Let dry 1-2 days
6. Prime with 5-6 drops juice

Sounds like a lot of work, but I have maybe 3 minutes total time invested in cleaning the atomizer and it's clean, like new.

what is a burn off??
 
Status
Not open for further replies.

Users who are viewing this thread