How do i use this atty?

[Jerry B]

So postal Santa arrived today with my order of 15 Mega LR 1.7 (THE RESURRECTOR) (Crystal Clear vaping) . I must admit i am at a loss here. I have only used the eGo T to this point. I am dying to explore more vaping but not sure how to use them. I popped off the little white cap and there is a hole that goes all the way through the atty. Now correct me if im wrong but if i put juice in this thing wont it leak on the battery and destroy said battery?

BTW word of warning about CCV. they sent me a syringe for injecting juice. I made a serious mistake in thinking the needle would be like a printer ink refill needle (rounded). Boy was it a mistake to tap my finger on top of that needle. nearly went all they way through my finger! Guess next time i should LOOK before i do something so dumb LOL

 

[Jerry B]

I think i figured it out. HOLY MOTHER OF GOD! that is powerful, um maybe time to start dialing back the nic level. 24mg menthol about peeled my eyeballs. It is so good.

 

[cigarbabe]

You don't put the juice into that middle hole. You will use the needle to inject juice around that hole into the cartomizer filling. I'm not sure if the Resurrector's are Dual coil or not but if they are you may want to look into device that can provide a higher wattage.
Also check out youtube.com for resources on how to fill cartomizer and how to use other devices.
Good luck!
C.B.

 

[JD1]

Wise words above. ^^ When you're done filling, hold a tissue to the bottom and give a couple of puffs through that hole to make sure there's no juice in there. If you're using an auto battery, juice leaking into it will stop it from working.

 

[dotma]

Good to know it peeled your eyeballs! LOL I am anxiously awaiting mine from the same place and I want it to be that good!

 

[Jerry B]

Oh Dotma your in for a treat. I was vaping Tonics menthia (puresmoker.com). It was already good but those RESURRECTORs were insane. Lets put it this way eGo atty= water LR resurrecters= Rum & Coke. Wicked throat to it and so cool it gave me shivers. Is it any wonder more and more people are tossing the analogs in favor of vaping

 

[washvap]

The method I use is to drip on the edge of the filler material that is around the tube. 45 drops and letting it sit for 20-30 minutes afterwards to let it soak into the filler. Then vape away, this will prevent you from getting a burnt carto and maximum vaping enjoyment.

 

[Iffy]

Boy was it a mistake to tap my finger on top of that needle. nearly went all they way through my finger! Guess next time i should LOOK before i do something so dumb LOL

Besides age, maybe vendors need to establish an 18 IQ minimum also...

Hey... whoa... just kiddin'...

On da serious side, guess I'll have to try some of dem Resurrectors. Sure will be tough to beat the 1.5Ω dual coils I'm using...

 

[mynameisrob]

Thats why I recommend the Ressurecotrs to everyone bc they are sickk.

For filling them I would NOT drip into them. They hold 2ml of juice and are pretty big. Dripping will take a LONG time for it all to settle and if you dont wait long enough you could easily singe them and ruin them.

I originally posted thos is another thread for someone that asked how to fil the Ressurectors. Use the needle that comes with them. its perfect.Heres the copy and paste.

How to fill a cartomizer with a syringe:

"All you have to do is take the dropper part of the bottle off your juice and fill your syringe with 2ml for a new carto. Take the rubber tip off the carto and carefully insert the needle down the side pushing against the metal. DO NOT go thru the filler because it will move it and you could potentially break a connection and your carto. Slide the needle down the side and go all the way to the bottom. Then slowly start dispensing some juice. Dont dispense it all bc then it won't be evenly distributed. Put alittle in, then take it out and insert the needle in a different spot. I normally do it in 3 spots (in a triangle) I found it distributes the best, but you could just do it in 2, on opposite sides. Make sure the needle is at the bOttom bc then you will not have to wait at all for it to settle. Disperse slowly and you will begin to see the toP of the filler become slushy. It is full then, don't put more. If its a new carto is will def hold 2ml, if your refilling it won't take a lot so pay attention and once it gets alittle slushy stop. While your filling hold a napkin or something under the carto bc if you do it too fast a few drops will come out the battery end. If that happens its only bc you did it too fast and the poly fill didn't absorb quick enough.( that happens to me bc I am impatient and fill it in about 10 sec, so I just hold a paper towel or napkin underneath.) wipe up the drops and put the rubber cap back on the carto. Then put the carto between your hands and rub back and forth spinning the carto quickly. This will insure the liquid is evenly distributed in case you put too much on one side from the syringe.
Now you have a perfectly filled ressurector that is ready to be used right away!"

There ya go. Let me know if you have any questions

 

[mynameisrob]

Many people feel the Ressurectors produce vapor similar to a dual coil, but they are single coil and dont drain the battery close to as fast.

Follow the directions i posted aboive on filling them and they will last a LONG timeand you shouldnt have any problems. The frst fill is important. One im using right now ive been using for the last 4 and a half weeks. Since ive started using them ive never gotten one DOA or bad one, and thats through about 15 or so 5-packs

 

[mynameisrob]

Also, technically the Ressurectors are designed for a 3.7V PV. While they work on a lower V PV like an eGo, they are not at their full potential. I use them on an E-Power and they are insane. If you like them that much now on your eGo, just imagine what it be like if you were using them at 3.7V. Also do NOT use them on higher voltages. They can do lower but NOT higher. You might be able to use them for alittle, but any extended uses at Higher voltages and your almost ensuring that your going to blow the coil.

 

[Iffy]

Also do NOT use them on higher voltages.

OK, 1.7Ω at 3.7 VDC is right at 8 watts. But I've been using 1.5Ω at 11.5 watts for over a month with no losses. Why would the Ressurectors be more vulnerable?

 

[dotma]

Oh Dotma your in for a treat. I was vaping Tonics menthia (puresmoker.com). It was already good but those RESURRECTORs were insane. Lets put it this way eGo atty= water LR resurrecters= Rum & Coke. Wicked throat to it and so cool it gave me shivers. Is it any wonder more and more people are tossing the analogs in favor of vaping

Oh man, I am gonna be super-stalking the mailman now! And Mynameisrob--thanks for the filling the carto thing! Very helpful!

 

[JD1]

OK, 1.7Ω at 3.7 VDC is right at 8 watts. But I've been using 1.5Ω at 11.5 watts for over a month with no losses. Why would the Ressurectors be more vulnerable?

Two reasons why the duel coils hold up well under high voltage. The biggest is because the current is divided between two coils, and neither coil gets as hot as a single coil would at the same wattage. The second is wicking time. With twice the surface area, juice will wick with the same efficiency, but times two instead of one.

If you slide the transport out to around 14:30 and start from there, you can see both a boge and a duel coil dry burned to the point of failure.
Kanal von pbusardo - YouTube