How dose this coil look

[Tankarax]

This is my first coil I ever built It is 1.2 ohms is it to high up to low It is sitting on a vamo v5 I will be getting a ivp v2 or a segelei 50 watt next week some time to use all 4 post I am open to all advice as I r n00b to bulding coils

 

[SLIPPY_EEL]

as long as you get the coil level with your air intake hole on the atty & as close as possible without touching you will be good and get full flavour from it, from what i can make out it looks like a tidy coil, is that on a w6? if so you have to double check the distance between coil and atty inside wall when you have the cap on as you have a little less room than what you see when you look at the atty as you have it in the photo

 

[Tankarax]

this is what the out side looks like i am sure it's a clone it only cost me 15$ at the smoke shop and it's not touching the wall at all. Was not sure if I used to much wick or not enough lol was a little nervous

 

[AnthonyMTSU]

Just make sure to get airflow to hit that coil. Cleaner then my first build.