How long do the Sapphires last?

[caged]

Can anyone tell me how much juice I can expect to put through one of these before it goes bad?

 

[mwa102464]

It doesn't go bad, you just pull out the bottom connector and put a new piece of wick in it, clean your bridge a bit, other than that the thing should run for a long time ;-)

 

[hunter55]

were do you get the wick at?

 

[haft2doit]

were do you get the wick at?

If you have any ce2's lying around just cut a piece of that. I don't know where to get just the wick.

 

[ZebadeeDoodah]

If I recall correctly, bad said he was getting some in.

 

[badkolo]

yes it should be here any day then ill put it up for you all.

 

[hunter55]

will they work for the vision as well?

 

[caged]

Thanks,

Sorry for all the confusion on your products, but what is the difference between the Vision and the Sapphire? I should probably buy a pack of each to test them out.

Also, I noticed you have a product that looks almost like an inline feeder called a pump cart. How well do those work compared to dripping? Does it come with everything you need (i.e. do I need other carts as well?).

 

[badkolo]

Thanks,

Sorry for all the confusion on your products, but what is the difference between the Vision and the Sapphire? I should probably buy a pack of each to test them out.Vision is a large capacity TOP COIL clearomizer which uses wicks in the tank to draw juice to the coil at top, Similar to a Ce2 but from a separate company and it has it own features that people like, the Sapphire is a smaller clear tank atomizer that has a atomizer at the bottom with a tank on top of it that feeds juice to the atomizer below, they are very different and need to be experienced to see which you would like, both are very popular and hvae their own advatages

Also, I noticed you have a product that looks almost like an inline feeder called a pump cart. How well do those work compared to dripping? Does it come with everything you need (i.e. do I need other carts as well?)The pumpcart is tank that fits into a 510 or 901 atomizer, the juice inside is fed to the atomizer by pressing the button and taking a draw which releases juice to the atomizer, then you fire your device and vape, it works extremly well and there is major news coming regarding the pumpcart.

I edited your post with answers for each question.

 

[Ellisd]

I do not replace my wicks. I find it easier to whole them with a tweeter and burn them with a lighter until they are clean. Then I put them back in.

 

[antfuzz]

Someone in another thread was talking about replacing the wick with a wire mesh the same mesh is used in the Genesis project. Has anyone attempted to do this?