How much time do I have to leave the tank to soak before using it?

[coronamorexxx]

Ok I got my first tank here, it's a protank 3 mini.

Guys said I have to put the eliquid on it and let it soak for some minutes, how long?

 

[madrabbit]

2 to 3 min u are good to go.

 

[SuperTaz]

Hi corona.....like rabbit says... a couple of minutes then drag a few times without firing the battery to make sure the wick is completely saturated.

 

[WharfRat1976]

Then take a few dry pulls on it to get the air lock sitchiated. This will. begin the process of pulling your joose into your coil from your tank. Start out at the lowest wattage with burst fires and slow draws to break the coil in properly and gradually increase power to your desired vape. This will enable your coil and wicking to match up and last as long as possible without frying out your coil from the get go. Vershtay?

 

[Cloudmann]

Yep.Always prime a coil by taking pulls on it without firing. This gets the juice flowing. After that, 2-3 minutes should be plenty, bit I always wait 5 just in case. Don't want to burn a coil due to impatience.

 

[madrabbit]

I burn a few coils cos of impatient hahahaha....

If u prime ur coil good it last at least 5 to 6 tanks of 2ml, but it may not due to juice that u use.

On nautilus bvc coil, It last me about 6 tanks with fruits and mint flavor and 50/50 pgvg ratio. But if u use juice like vanilla or custard or coffee flavor or any flavor that's creamy than ur coil will not last too long.

This are base on my 3 months experience hahahaha....correct me if I'm wrong.

 

[jseah]

I am on the ninth day of the same BVC coil on my Nautilus Mini and it is still going strong, and I put 3 ml through it a day. Once the tank drops down to 0.5 ml, I top it back off to 2 ml. I do this twice a day. By this time tomorrow, I will have put 27 ml through the coil.

 

[madrabbit]

remember that don't vape when ur juice level lower than the coil hole where u can see the wick.