how to clean my nemesis and kayfun.

[im_coryy]

how would i go about doing this? i have the matte finished nemesis with stainless steel. ive been thinking i can use hot soapy water to clean the tubes (like dawn dish soap and a toothbrush). and i was thinking about using rubbing alcohol to clean my silver contacts, then wipe everything down with a soft cloth, like a tshirt. would this work?

 

[Jstcriusen]

Dawn will do nicely.
I did the same with the kayfun and when I was done I took out the center post and rinsed it all out with alcohol and blew it out.
The tooth brush I'd just use on the inside of the tubes on the nemesis and hand wash the outside.

 

[doghair]

I have never used anything but dawn dish soap and have had no issues at all.

 

[Submaniac]

Dawn and a toothbrush will work to clean tubes

i was thinking about using rubbing alcohol to clean my silver contacts

I would recommend using a WHITE ERASER (not the colored ones) on the contacts. Use the eraser on the contacts as if you were trying to erase pencil writing off a piece of paper. It will remove all oxidation/tarnish but leave the silver intact.

 

[im_coryy]

I have never used anything but dawn dish soap and have had no issues at all.

even th contacts

 

[doghair]

even th contacts

I was talking about the kayfun and the initial cleaning of the mod. You shouldn't have to do anything to the mod after the first scrub down but wipe down the outside and clean the contacts occasionally. Dude nailed it with the pencil eraser, that will be the best on those.