I am using a kangertech subox with subtank mini RBA, I know its sounds pretty dumb to ask this question but i am getting so much of flavor from the vapes. 0.5 OHMS, 3.3V with 23 Watts. My girl is using the same ejuice with the same kangertech Rba but her flavor is mild and enjoyable. i want it that way and i was wondering if someone could help a newbie to vaping out. I am be glad to hear for your kind suggestions. Thank you
How to decrease the flavor of the Ejuice abit
- Thread starter Riksel`
- Start date
- th_trl_thread_readers 0
- Status
You could buy some VG and PG or a 50/50 mix and dilute your E-liquid a little but it will lower the nic a bit.
What is DIFFERENT about HOW the Girlfriend is vaping? If you are using the same juice and same equipment.... Then how that equipment is being used must be why the flavor is different. Tighter or looser draw, more or less wattage, ect.
Yes you could dilute your juice with VG/PG/Nic base to reduce flavor.. BUT you say she get milder flavor from the same juice already. Figure out what she is doing different.
Yes you could dilute your juice with VG/PG/Nic base to reduce flavor.. BUT you say she get milder flavor from the same juice already. Figure out what she is doing different.
That could be it but since we are all different it could just be that his taste buds are different than her taste buds.
You have already gotten some good advice. It is always good to have some unflavored e-juice around for cases just like this.
You did not give Her device settings.
Same Juice
Same Tank
Same mod?
Same resistance?
Simple solution, hatch her gear.
I never was a big fan of flavors...any flavors. I always had to dilute. Just buy a higher nic version of what ever you are using and dilute it with pg/vg at whatever ratio you use. PG at Tractor Supply. VG at Walmart. Or get it online.
You can ask whatever vendor your buying your juice from, to mix it with a little lighter flavoring. Should-not be an issue. As for your current juice, just mix it with some unflavored. Use a DIY E-liquid calculator (found on google) to figure out what MG to buy the unflavored in, to achieve a MG amount that you'd enjoy. That'll do it. OR, lower your wattage, and experiment w/tighter and looser airflow control. Some juices bloom with MORE airflow, some juice's flavor will bloom with a tighter airflow.. figure-out what airflow you enjoy for that particular juice flavoring. GOOD LUCK! 
If your girl is "using the same Ejuice with the same kangertech Rba", it seems you need to match her build & watts.
I did say in the above, its the same juice, same mod which is kangertech sub mini with subtank mini. resistance is the same too 3.3v
its a 70/50 juice with same mod, juice and the tank and the draws are on the most open loose airflow. wattage and resistance is also the same mentioned above.
If you are both using pre-built heads at 0.5 ohms, hers might be a bit different from yours. It happens and it can make a noticeable difference to the vape.
If you are both using the RBA deck, the same applies but it's from differences in how you built them.
If you want to check this out a bit more, try swapping attys. If the flavor difference follows the atty the atty is where it's coming from. If the difference follows the mod, they are probably putting out different power at the same settings. My bet is it's in the attys
If it is in the attys, try swapping the heads.
Hope that helps.
Has to be something different to make it taste different..... As Ryedan mentioned. Mods are not outputting the same, I'd be surprised if they were, no mod works at 100% efficiency, if only because no 2 batteries feed power at exactly the same rate. Something is different in the coil build or wicking... The wick is a very likely suspect.
I used to find all flavor too strong, pretty much have the same setup, before I started making my own juice I used to buy double my normal nic level pour half of it in a empty bottle and fill the rest up with VG to mute the flavor a bit.
If you do do this, mix it well and let it sit for a couple days.
With all due respect to the more knowledgeable vapers who've replied, seems like worry about the equipment is too complex when just cutting the juice would accomplish the task.
That exactly! There isn't a problem with your equipment if you're getting lots of flavor lols.
That's a very good point HauntedMyst
. OTOH, if you cut the juice to get what you want from the hardware you've got, you'll have to change the mix again when the HW changes. If it's a HW issue at all. Once you know where the issue is coming from you've at least got that knowledge to help you move forward.
No, no more knowledge. I'm full and I have a headache. There is too much in there and anything I hoped to learn about my other hobby (Russian nesting dolls) won't stick.
- Status
Similar threads
- Locked
