all you need is a can of aircraft remover it can be bought at auto zone for around $9 . a can will probably last the rest of your life for striping mods. other things you will need are some cotton balls, a few q-tips ,2 rags, and some gloves
1, get a plate or bowl and spray some remover on the bottom of it
2, dip the bottom of your mod in it and stir it around get the bottom covered in remover
3, stuff a bit of cotton in your atty connection and spray the mod with remover
4, wait about 5 minutes and start pealing the paint off should come right off use q-tips for hard to reach places
5, use a rag to get any little pieces of paint left on it
6, put some water or solvent on a clean rag and clean the mod and your done
1, get a plate or bowl and spray some remover on the bottom of it
2, dip the bottom of your mod in it and stir it around get the bottom covered in remover
3, stuff a bit of cotton in your atty connection and spray the mod with remover
4, wait about 5 minutes and start pealing the paint off should come right off use q-tips for hard to reach places
5, use a rag to get any little pieces of paint left on it
6, put some water or solvent on a clean rag and clean the mod and your done
