How to get atty connector?

[foretwoone]

Cant figure out how to remove an atty connector from a 510 battery. Tried pulling it and soaking in acetone.

 

[Nietzsc]

I'm trying the same thing here but I haven't been able to remove it yet

 

[four2109]

http://www.e-cigarette-forum.com/forum/battery-mods/77002-salvaging-battery-connectors.html

 

[ejoker]

probably not the best way, but here's mine.

dremel just below the connector, but just deep enough to cut the outer shell, and not the battery. screw on atty, hold batt with pliers, and back n forth twist till it comes loose.

 

[Nietzsc]

Done! I grabbed the atty with some pliers and then heat it up with a lighter, then screw the atty to a battery and start working it (pulling and rocking it sideways) until it came out.

 

[Rocketman]

I leave the 510 connector in the stainless steel shell.
Stronger with the shell. A little epoxy for insulation.

 

[Sgood1971]

I leave the 510 connector in the stainless steel shell.
Stronger with the shell. A little epoxy for insulation.

How to you know where to apply the tube cutter? What's the measurement?

 

[Rocketman]

Center picture shows dimension. For mine it's 0.3 inch. I cut then file back the outer to give good exposure to the center then epoxy insulate the outer. I use the center as the direct positive battery connection is a buttswitched flashlight mod. Shell connector shell is press fit into metal washer and epoxied on back side.

 

[Sgood1971]

Center picture shows dimension. For mine it's 0.3 inch. I cut then file back the outer to give good exposure to the center then epoxy insulate the outer. I use the center as the direct positive battery connection is a buttswitched flashlight mod. Shell connector shell is press fit into metal washer and epoxied on back side.

Sorry, didn't notice center pic, my eyes are pretty bad.

 

[Rocketman]

Blew up picture a little